help! Прошивка IAUDIO U3 Опции

[catdog]

Пыталась следовать инструкции из темы про U2. Дошла до указания вынуть батарейку. По-моему она не вынимается....Что делать?

[catdog]

Все напутала...У меня U2. А пыталась делать по инструкции к 5.

[dolphinik]

))))

[catdog]

Смешно, но не мне. Я все еще не могу найти инструкцию по прошивке iaudio u2. Можно на английском.

[catdog]

Спасибо, нашла на английском.

[dolphinik]

Выложи сюда, плз. Мало ли ещё кому пригодится

[catdog]

iAUDIO U2 Firmware V.1.68

[Improved Features & Fixed Bugs]
- Integrated version of multi-lingual menu languages. (Select a county when player boots up) - Fixed the error that large capacity files (512MB or high) aren't stored.
- Revised wrong words on multi-lingual menu languages.
- Fixed other bugs. * If total capacity of memory size is smaller after the firmware upgrade than before, please format your iAudio with windows explorer. The total capacity will then be restored to normal. [Download]iAUDIO U2 Firmware V1.68 Beta1[Warning/Caution]
- Firmware update must be performed in 'Recovery Mode' when updating from previous firmware to the latest firmware. The same rule applies to firmware downgrade when rolling back from the current firmware to an older version.
- If not in 'Recovery mode', installation will shut down with the following error message: "Please use 'Recovery mode' to install new firmware!"
- Before installing new firmware, existing firmware must be removed from iAUDIO U2.

There are two ways to remove existing firmware from iAUDIO:
1. Control Panel -> Add/Remove programs -> Remove iAUDIO U2 [Cowon digital Audio Player]
2. Start -> Programs-> Cowon System -> Remove- Please close all other programs during installation* Do not remove the USB cable right after upgrading firmware.* When completing upgrading firmware, iAUDIO automatically turns off and on again. Please check that your iAUDIO is recognized as a removable disk before removing the USB cable from the computer. Because it sometimes displays that it is done before completing upgrading firmware under some special condition such as Windows 98.

[Installation steps]
1. Download the latest firmware.
2. Unzip the installation file and run 'Setup.exe.'
3. Click 'Agree' -> 'Next' -> keep following steps in the installShiled wizard.
4. After finishing installation, go to Start -> All Programs -> Cowon -> iAUDIO U2 -> 'Firmware download' to run the firmware upgrade program. The firmware upgrade program searches the device.
5. Press PLAY button on your iAUDIO U2, and keep pressing it.
6. Connect iAUDIO U2 to a PC by using a USB cable.
7. Keep pressing PLAY button until windows begin 'New hardware found' wizard.
8. The wizard recognizes iAUDIO U2 in Recovery mode, and brings up the firmware update window on the screen.
9. Click 'Start' to begin installation. Updating firmware also format flash memory, so make sure to back up all your files before installing.
10. After finishing installation, remove iAUDIO U2 from a PC.
11. Go to Menu -> Information on your iAUDIO U2. You can check the upgraded version of firmware.
==================================================
Firmware V1.65
- Fixed the error that the player freezes when too many WMA files are stored in one folder.
--------------------------------------------------::
Firmware V1.61
- Fixed the error that reduces playback time.- Fixed the error of the same pattern in Suffle mode.
- Fixed the error that excludes some songs in Suffle mode.